Once you have set up your A2+Wireless speakers, turn them on using the volume knob on the rear panel. The speakers will automatically enter their "pairing mode" when first turned on. The Bluetooth LED on the back of the powered speaker will blink during this time frame.
While the LED is flashing, go into your source device's Bluetooth menu and then search for nearby Bluetooth devices. Select the A2+'s from the list of nearby devices to pair and connect with the speakers. Once your source device has been paired with the speakers, the LED light on the back should remain solid and on.
At this point, select your favorite tunes and hit play! Keep in mind that you can adjust the volume by using your source device's volume control along with the volume knob on the front of the speakers. If the volume seems too low, check to make sure the volume is set to an appropriate level with both your source and the speakers.
If you'd like to switch to another Bluetooth source, either press and hold the LED button on the back of the A2+'s until it starts flashing OR go into the Bluetooth menu of your source device and disconnect from there. Once the LED on the A2+'s begins to flash again, you can pair a new Bluetooth source to the speakers.
While the LED is flashing, go into your source device's Bluetooth menu and then search for nearby Bluetooth devices. Select the A2+'s from the list of nearby devices to pair and connect with the speakers. Once your source device has been paired with the speakers, the LED light on the back should remain solid and on.
At this point, select your favorite tunes and hit play! Keep in mind that you can adjust the volume by using your source device's volume control along with the volume knob on the front of the speakers. If the volume seems too low, check to make sure the volume is set to an appropriate level with both your source and the speakers.
If you'd like to switch to another Bluetooth source, either press and hold the LED button on the back of the A2+'s until it starts flashing OR go into the Bluetooth menu of your source device and disconnect from there. Once the LED on the A2+'s begins to flash again, you can pair a new Bluetooth source to the speakers.
