There isn’t a need to connect a ground wire as this is a connection that is needed between the turntable and it's phono preamp (whether the preamp is built into the turntable, or external). When going from the very low level of a phono cartridge, it's easier to pick up noise when bringing this signal up to line level, and the ground wire helps with this. On an internal preamp turntable, this connection is located inside the turntable. When going from the line level RCA out of a turntable with an internal phono preamp or the line level outputs from an external phono preamp to the inputs on your speakers, this connection is not needed.
Articles in this section
- Can I increase the length or change the speaker wire between each speaker?
- What if my speakers or subwoofer have a hum or buzzing sound?
- Can I use a subwoofer with Audioengine powered speakers?
- How do I connect bare speaker wire to my speakers?
- Can I turn Bluetooth off so my neighbors can't connect to my speakers or B1?
- Why do I hear my phone's notifications over Bluetooth?
- Where do I connect the ground wire from my turntable to the speakers?
- Why do I have to plug one speaker into the wall?
- Audio and video aren't in sync when using Bluetooth. This wasn't happening before, what gives?
- Will the sound be affected if I place the left (active) speaker on the right side and the right speaker on the left?