Because Audioengine active speakers already have an amp built in, you never want to connect it to the amplifier output of a stereo amp or AV receiver that would typically connect with bare speaker wire or banana plugs. If you want to use an existing AV receiver as an input switcher and that system has preamp outputs (these would typically be RCA), you could connect these to the RCA inputs on your Audioengine powered speakers.
Articles in this section
- Can I increase the length or change the speaker wire between each speaker?
- What if my speakers or subwoofer have a hum or buzzing sound?
- Can I use a subwoofer with Audioengine powered speakers?
- How do I connect bare speaker wire to my speakers?
- Can I turn Bluetooth off so my neighbors can't connect to my speakers or B1?
- Why do I hear my phone's notifications over Bluetooth?
- Where do I connect the ground wire from my turntable to the speakers?
- Why do I have to plug one speaker into the wall?
- Audio and video aren't in sync when using Bluetooth. This wasn't happening before, what gives?
- Will the sound be affected if I place the left (active) speaker on the right side and the right speaker on the left?